Problems with Motec M800 P&P
Thread Starter
Newbie
Joined: Jan 2014
Posts: 4
Likes: 0
From: manchester
Problems with Motec M800 P&P
Hello, I have installed a Motec m800 along with diff and C125 RLK
3 sensors attached too the display (got I/O upgrade)
3 attatched to the ECU
Display is reading only voltage took ages to get it out of demo mode and Im very confused wiring is perfect.
Biggest issue is the Lambda Im using a BOSCHE LSU 4.9 for some reason its not reading it at all. its not a wiring issue as it was grounded without ECU and the sensor heated up so we know its ok tested all wires and all pins Im doing my head in has anyone got any input in how to configure C125 to ECU and what paramiters to use for LSU? whats the likelihood ECU is broken? How can i Test the lambda? Could that be broken? Im really at a loss.
Thanks a lot
Yoda.
3 sensors attached too the display (got I/O upgrade)
3 attatched to the ECU
Display is reading only voltage took ages to get it out of demo mode and Im very confused wiring is perfect.
Biggest issue is the Lambda Im using a BOSCHE LSU 4.9 for some reason its not reading it at all. its not a wiring issue as it was grounded without ECU and the sensor heated up so we know its ok tested all wires and all pins Im doing my head in has anyone got any input in how to configure C125 to ECU and what paramiters to use for LSU? whats the likelihood ECU is broken? How can i Test the lambda? Could that be broken? Im really at a loss.
Thanks a lot
Yoda.
Thread
Thread Starter
Forum
Replies
Last Post
FS[MidWest]: Motec M800 PnP for Evo 9
Mitchubishievo
For Sale/WTB - Engine / Drivetrain / Power
17
Nov 28, 2017 03:13 AM
Lolo La Torche
Water / Methanol Injection / Nitrous Oxide
3
Nov 10, 2017 06:42 AM
fireroasted
Evo Electrical / Audio / Security
3
Sep 16, 2009 10:21 PM
han74j
Evo Engine / Turbo / Drivetrain
5
Aug 4, 2004 08:49 AM