I just got a cobb accessport that I bought off another member on here, and with out knowing, the back of the accessport where the obdll connector would clip onto is broken, right where the clip snaps onto. Can I still flash my car? Is it safe?

 

as long as the pins are not bent deformed or look as if they were bent back into place you technically should be good. just make sure its fully seated when your flashing if it falls out during a flash then your going to have a bad time. maybe put a piece of tap to hold connector in place. if you feel uncomfortable with they way it is, try getting your money back.

 

Thanks, I gave it a shot, worked fine.. I'll probably just upgrade it to the v3 soon.