How do you unlock Bluetooth without the password?
Newbie
Joined: May 2021
Posts: 1
Likes: 0
From: vancouver
RESETTING BLUETOOTH® (HANDSFREE) PASSCODE — 2007 & later Outlander, 2008 & later Lancer/Lancer Evolution. When pairing a Bluetooth handsfree device to a vehicle, the customer is asked to create a 4 digit passcode as a security precaution. This code is only used when the customer makes specific changes to the profile for that device and customers may forget what code they entered during the original pairing procedure. If the vehicle is equipped with handsfree module part number 8785A003, use the following reset procedure to reset all passcodes and clear the system:
* Turn the ignition to the ON position.
* Press and hold the "hang-up" button for 2 seconds.
* Release the button and repeat 2 times. Do not exceed 10 seconds total time.
The customer can now re-register the handsfree device with a new passcode and change its profile.
* Turn the ignition to the ON position.
* Press and hold the "hang-up" button for 2 seconds.
* Release the button and repeat 2 times. Do not exceed 10 seconds total time.
The customer can now re-register the handsfree device with a new passcode and change its profile.
I realize this is an old thread, I have an old outlander (2009j the dealer quoted me around $300 to unlock the Bluetooth/voice command. Yeah.
I tried your instructions, many times, to no avail. Any suggestions of any other reset processes? At one point it sat without a battery for a few months and when it was restarted it went through a Bluetooth cycle, but I didn’t have the code so it locked up after the second attempt.
help would be appreciated.
thanks
Give this a shot if you have the Nav/MMCS. If not, the only instructions I've seen are already in this thread.
For the earlier MMCS-1: press and hold the Settings button and the Map button together for at least 4 seconds. This gives you the 'Service' screen. Touch 'Hands Free Module'. The next menu then has an 'Unlock' button at the bottom of the screen.
For the later MMCS-2: press and hold the 'Info/Set' button and the top of the 'Seek Track' button for at least 4 seconds and proceed as above.
For the earlier MMCS-1: press and hold the Settings button and the Map button together for at least 4 seconds. This gives you the 'Service' screen. Touch 'Hands Free Module'. The next menu then has an 'Unlock' button at the bottom of the screen.
For the later MMCS-2: press and hold the 'Info/Set' button and the top of the 'Seek Track' button for at least 4 seconds and proceed as above.
Thread
Thread Starter
Forum
Replies
Last Post
gimpydingo
09+ Ralliart How-To/Installations
16
Aug 8, 2015 07:25 PM
evokel
Evo X Electrical / Audio / Security
1
Jul 8, 2013 07:33 AM
hccyong
Lancer Troubleshooting
15
Mar 29, 2011 11:23 AM
