Hey Do you guys drill into the bumper at the ends of a lip? ( inside the wheel well) . I don't feel like doing it since its easily visible if the lip is not installed.

Thanks, Dan

 

What lip? I did on my JDP but i used black screws and run the lip all year....

 

Its a JDP aswell. I was just trying to avoid drilling somewhere that can be potentially be visible if I decided to remove the LIP in the Future.

 

Get some 3M tape and put it there then. They make some for cars that are good for very low and high temps and hold like 100LBs... that should work just fine however, make sure you keep an eye on it to make sure its not coming off b/c that could be very bad LOL!

 

3M High Strength and maybe some custom brackets to allow a couple screws on the under side. I'd always want some mechanical fastening for body parts.

 

Any pictures of the finished product?

 

Here you are

 

SEXY! She really looks good!

 

loooks good

 

Looking good! This will be a great help

 

Did you end up drilling anything for this?

 

i didnt drill anything i just used the screws it came with and some 3M tape in a few areas.