Has anyone installed an aftermarket shift knob for the MR and cleared the "Reverse Lockout Ring"? I couldn't seem to find a knob that fits. Thx.

 

The ARC Dark Titanium ball knob fits like a charm.

 

Nice !!! I t looks like it should have been there from the get go ..

 

wow that looks really good. I still have the stock knob on my car (blk leather) they never installed the MR one at the dealer and when they finally shipped it to me, I decided I didn't like the look of it, so I never put it on. What Bride seat is that?

 

hmm, so this ARC knob fit the reverse lockout ring without any modification? I was under the impression that it had to be modified slightly for the 6spd.

kmxxbadboy, can you confirm?

 

WORKS should have our 6-speed Grab available soon.

 

what about the 6-speed short throw?

 

Very sharp knob and indeed very sharp Bride seats. Where did you get the knob?

 

i would like to know about the 6 speed short throw as well

 

On the pic, it does look like you cut off the top section of the reverse lockout ring to make it fit, correct?

 

Nope, not at all. The knob actually has space in the hole to allow the lockout lift piece to go up and into it.

 

Thx Mike for the info. Do you know if the EVO's thread is M10x1.25 (I think but not sure) or M10x1.5? Evasive used to carry them but no longer does. Where did you get yours?

 

It's M10 x 1.25. Adam from Z1 Performance can get them for you. Drop by at www.z1auto.com.