Ok so this winter I am going to start to mod my car I want to have some were around 350whp using the stock turbo and if possible pump gas. I have been doing some research but getting mix results any answers could help thank you

 

Well depending on the dyno, 350 on the stock turbo isn't too arduous of a task.

If you put it on a dyno jet, you can probably hit 350 with a TBE and TP, MBC @ 24 psi, Intake, 02 housing, Intercooler + Piping etc...

I made 348 whp on a mustang dyno (the lowest reading dyno) on the stock turbo on 93/alky, tbe with a cat, cams, walbro, no intake or IC or anything just 28 pounds of boost and 90 degrees outside. You can have 350 safely on your DD with no problems but depending on the dyno and weather. I lost 20 whp FWIW between April and July just from heat.

 

cams,tbe,fuel pump, boost control, intake, upper and lower intercooler pipes, tune, and meth kit should put u in that ball park

 

TBE, MBC, and a reflash should already get u close to that with a IX

 

it's easy to make that sort of power on the IX

you'll need a

-TBE "Check buschur the most proven exhaust for most gain" $800
-MBC $90
-Walbro $80
-Intake $300
-02 Housing $200
-Cams $600
-FMIC "ETS Intercooler Kit comes with upper and lower ic pipe = $829
-Tune = $200

Total about $2,800
with these mods im sure u'll be making a bit over 350whp too ..

 

^ agreed. I can almost guarantee... Fuel pump, intake, TBE, E/MBC, and a good tune... on a MIVEC will get you a safe 350 whp. There is a really good tuning shop in my area that has done this a number of times with the IX's. And yes, I didn't say anything of FMIC, injections or anything of the sort. Just straight up 93 oc pump gas and some damn good tuning

 

lords3t if your talking about AMS MD they use a very high reading dyno you don't need a FMIC or injecTORS or anything of that sort on their dyno but like you will probably need it on a lower reading dyno.

 

350 a cake walk with an 06. Turboback exhaust, a flash intake little more boost and youre almost there

 

+1

 

what about an evo 8 with tbe, mbc, tune and k@n cone filter?

 

You are not going to be a 350whp with those mods on an 8.

 

Yea, but what will you be at on an 8 with those mods? What is needed for an 8 to reach ~350whp

 

just keep savin cause your going to want more power

 

Throw in some cams, bigger hotside for the turbo and youl be closer

 

I just bought an evo ix and want to be around the whp as well
so far TBE, boost controller (dont know if manual or elec. yet), walbro, and 93oc
all this should be under 2grand