Hey guys, I just bought my first 06 evolution! First off, It came with an HKS blow off valve vented to the atmosphere,a poor intercooler piping set up wich was leaking in many places. I went ahead and ordered the ETS upper,and lower intercooler piping kit,along with a stock recirculated blow off valve. Now, it also had an injen intake wich will not fit with my new intercooler piping kit. What is a good intake kit that will work best with this setup? I was looking at the perrin intake as I have no stock intake/air box to put back in.


My other concern is there is also a manual boost controller installed,and I want to make sure there is another nipple on the perrin intake for the boost source,or if I can feed it from another location. I came from the world of DSM's, and this is definitely a new learning curve.. Thanks!

 

if your getting all ets stuff just get an ets intake also

 

Will the perrin complete intake work with the ets piping kit,and stock battery location?

 

I have the ETS upper and lower intercooler piping and a AEM intake and it works great. Along with a hallman pro MBC on the wastegate and the compressor housing.

 

^ Do you have the ets piping on the stock fmic still?

 

why wont the injen intake work with the ets piping kit? cause its short route as opposed to stock?

 

If you can afford to go with the perrin intake (yields most power) then go with it. If you're worried about the fitment then just go with the ets intake and recirculation pipe. I currently have the ets short route and intake and they fit great.

 

welcome!!