EVOScan help
Thread Starter
Newbie
Joined: Nov 2006
Posts: 53
Likes: 1
From: Above 7000ft
EVOScan help
Hi everyone,
I am very new to EVOScan so this could totally be user error but I have two problems with the program right now.
I am able to use my tactrix cable to connect to my ecu with ECUFlash, but when I try to datalog using EVOScan the program either freezes (which no amount of "end task" clicking will close) or I get an error regarding COM1 not being able to open.
Any suggestions?
Thanks!
I am very new to EVOScan so this could totally be user error but I have two problems with the program right now.
I am able to use my tactrix cable to connect to my ecu with ECUFlash, but when I try to datalog using EVOScan the program either freezes (which no amount of "end task" clicking will close) or I get an error regarding COM1 not being able to open.
Any suggestions?
Thanks!
Hi everyone,
I am very new to EVOScan so this could totally be user error but I have two problems with the program right now.
I am able to use my tactrix cable to connect to my ecu with ECUFlash, but when I try to datalog using EVOScan the program either freezes (which no amount of "end task" clicking will close) or I get an error regarding COM1 not being able to open.
Any suggestions?
Thanks!
I am very new to EVOScan so this could totally be user error but I have two problems with the program right now.
I am able to use my tactrix cable to connect to my ecu with ECUFlash, but when I try to datalog using EVOScan the program either freezes (which no amount of "end task" clicking will close) or I get an error regarding COM1 not being able to open.
Any suggestions?
Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
ilikeppie
General Engine Management / Tuning Forum
9
Jul 7, 2021 03:10 AM
tsitalon1
Evo X Engine Management / Tuning Forums
11
Aug 17, 2010 08:02 PM