Hey guys,

Just wondering if anyones seen this before and whether this points to an earthing issue or whether i've got a bung unit.

-Running an Innovate LC-1 as above, wired into my stereo power and earth.
-Firmware at 1.10
-Calibrated correctly in free air
-LED is flashing for 10sec or so whilst in heating phase then goes solid indicating OK
-When the car is fired up Logworks gauge shoes an 02% of 20.9, then cycling from 1.3% back up to 20.9% again.
-Blipping the throttle makes the needle on teh gauge flash up at 7.5a/f and then goes back to nothing with the '02%' in the middle of the gauge.
-In Evoscan I think its reading the LC-1 input correctly as it displays the same 7.50 when blipping the throttle, then goes to 0 indicating the 02% issue, log attached.

-Is my issue the grounding location at the stereo? Or something further?

Cheers
Ben