MDP (boost) reading at idle in Evoscan
Thread Starter
Newbie
Joined: Dec 2010
Posts: 49
Likes: 0
From: Huh vai ee
MDP (boost) reading at idle in Evoscan
Hey guys , new to these cars-- have more of an E30 BMW background... Anyways, the Evo 9 I bought from a co worker has run terribly even before I bought it. Its got AMSs gt30r based kit in it with a walbro 255 and 880cc injectors. It runs fine at (very light) part throttle but the moment any sort of load is experienced/when it experiences the slightest bit of boost, she goes full lean... No DTCs... My first few times messing around with Evoscan, I noticed that the MDP (boost) was reading anywhere from 18-20 psi at idle
Shouldn't it be reading vacuum? Anyway, before I go out and buy a new MAP sensor, I figured I'd see if any of you guys had any knowledge you could graciously bestow upon me
Thanks!
Shouldn't it be reading vacuum? Anyway, before I go out and buy a new MAP sensor, I figured I'd see if any of you guys had any knowledge you could graciously bestow upon meThanks!
Thread Starter
Newbie
Joined: Dec 2010
Posts: 49
Likes: 0
From: Huh vai ee
It appears to be a stocker...
I'll be out of the country for a few days. I'll be excited to check for responses when I get back. Thanks so far RedRalli! BTW, I dated a girl on the island of Kauai from Killeen...
I'll be out of the country for a few days. I'll be excited to check for responses when I get back. Thanks so far RedRalli! BTW, I dated a girl on the island of Kauai from Killeen...
Last edited by scrivs; Feb 3, 2011 at 12:04 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Adrock
General Engine Management / Tuning Forum
8
Sep 17, 2005 05:57 PM
