3rd gear, high knock; 1-4 WOT No Knock....
#1
3rd gear, high knock; 1-4 WOT No Knock....
After having my car on a Dyno and not even being able to do a full pull because of it going 10.0 rich and misfiring, I decided to turn Lean spool off and retune. In trying to tune it I have found I cant get 3rd gear to be knock free. Ill drive the car a bit to get air flowing, slow down to 2500 in 3rd, start the log, go WOT and Ill immediately get a flashing CEL and see up to 13 counts of knock during spool up, and at least 6 the full rev range. Obviously I cant adjust anything like this. But ANY other gear, including a low 1st thru 4th WOT no lifting, I get ZERO knock. Should I just take 5 degrees out of the whole Rev range and start over? Its even in my logs that 100 load 2700 RPM is showing 3-6 counts....Not even in boost yet.
Stock block, Kelford 272s, Evo 9/20G at 26 psi, 3" turbo back, Injen piping, AMS IC, Denso 720s, 13.0-12.5 during spool up, 11.5 full boost, 11.0 at redline
Stock block, Kelford 272s, Evo 9/20G at 26 psi, 3" turbo back, Injen piping, AMS IC, Denso 720s, 13.0-12.5 during spool up, 11.5 full boost, 11.0 at redline
Thread
Thread Starter
Forum
Replies
Last Post
maknuge
Evo Engine / Turbo / Drivetrain
7
Oct 20, 2015 01:07 PM
dtuned
Evo Engine / Turbo / Drivetrain
4
Jun 4, 2009 02:02 PM