So I got my new Intake and Exaust installed... Car wouldnt start today.
Newbie
Joined: Jun 2007
Posts: 47
Likes: 0
From: Santa Ana, CA
Must have been one of your sensors wiggin' out. I had a 200sx SE-R before this car and my whole sensor system was 
to ****. The car would drive for a while untile the ECU figured out none of the sensors were working... it would then stall and not start for a few minutes
.
to ****. The car would drive for a while untile the ECU figured out none of the sensors were working... it would then stall and not start for a few minutes .
Newbie
Joined: Jun 2007
Posts: 68
Likes: 0
From: Florida
that would be the easiest way to avoid the headaches some other people are getting... disconnect your battery, install the intake, reconnect your battery, and as long as RRM did their job right you should have no problems...
if my intake ever arrives thats my plan of attack!!
if my intake ever arrives thats my plan of attack!!
Thread
Thread Starter
Forum
Replies
Last Post
evolution13
Evo X Engine / Turbo / Drivetrain
5
Apr 14, 2015 05:37 PM
evrblazin
Evo Engine / Turbo / Drivetrain
19
Apr 11, 2007 03:13 AM