Es
Thread Starter
Evolving Member
Joined: May 2002
Posts: 132
Likes: 0
From: NATI
Es!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
I know i didnt buy the best lancer out there i have an ES along with alot of other people, and i am sick of criticism and the lack of products, please help me rock make some stuff for the es also, and i catch greef for lowering my car with coil overs it was my only choice with the ES so have some consideration!
Last edited by cincyracer2002; Jul 28, 2002 at 08:40 AM.
Newbie
Joined: Apr 2002
Posts: 50
Likes: 0
From: Sacramento CA
I believe most of the Road /// Race products will work for your ES, excluding the REAR ANTI-SWAY BAR. In fact I believe most of the products available will work for the ES. There really isn't much difference between the models. Is there?
Any one else have .02 on this?
Any one else have .02 on this?
Originally posted by cincyracer2002
the eibach springs dont fit it, the lug pattern is different and there is some other stuff to like the sway bay u mentioned.
the eibach springs dont fit it, the lug pattern is different and there is some other stuff to like the sway bay u mentioned.
As for the springs...get the OZ perches and the same springs will fit. You have the same front suspension as the current Mirages. Mitsubishi no doubt cut corners and saved money by using existing parts for production of the ES. It's not the end of the world, it's just annoying.
If you ***** and whine and complain and keep telling companies there's a market...they will come.
Good luck.
Evolved Member
Joined: Dec 2001
Posts: 2,722
Likes: 0
From: Up to 80 miles north of Gilroy
Alright let's see if I can clear things up a bit...
ALL engine related parts will fit between every trim of the Lancer.
The difference between the ES and the LS/OZ is the front suspension.
Read up here.
As for the RRM lower tie bar, the ES either has a) the mounts the LS/OZ has but without the bar installed, b) no mounts but the bolt in holes are present or c) (worst case) the ES doesn't have anywhere in the rear to bolt up the bar.
ALL engine related parts will fit between every trim of the Lancer.
The difference between the ES and the LS/OZ is the front suspension.
Read up here.
As for the RRM lower tie bar, the ES either has a) the mounts the LS/OZ has but without the bar installed, b) no mounts but the bolt in holes are present or c) (worst case) the ES doesn't have anywhere in the rear to bolt up the bar.
