Ok First Off, You Dont Need Any Tools EXCEPT a phillips head sd. Ok first, goto passenger side. Down by the floor board is where you console paneling ends.....well there is a break where two pieces come together. They are only held together by two snap in clips. Just becareful and unsnap it. Becareful, again, i broke one piece of my paneling, well the clip piece anyway, but it didnt matter it still holds in like regular. Ok well after that it should be undone. Goto driver side and this is is a little more tricky. I just pulled the pieces apart b/c they only stay together by a few plastic pieces that over lap.... ----> <______ kinda like that...lol dunno how well that is. But after this you front should be loose. But your not done yet. Goto your console in the back and pull up the lid. There are Two screws, remove them. Then pull it out, there are two clips infront of the cup holders. Ok now you have two screws at the base of your front center console. Remove the, and thats it! Hope i helped you, you may have to fiddle with it to get it completely off but thats it. If these directions have already been posted, feel free to delete mine.

-Kelspar
**Note This Was Done On A Lancer ES Automatic!

 

Turn on your AIM and IM me, I have several questions.

 

No offense...but what was the point of doing this?

 

I think this belongs in the "Lancer How-To's" thread

 

Well the purpose is someone wanted to hook up some lights to there cigirette lighter and they couldnt get the paneling off, now they can.........and read the how tos, it says he wants to keep it strickly to INSTALLS.......this is just mods.

 

i think its very useful. i'll be installing an indash screen so this could help running wires to the brain under the seat!

 

just in time....
im planning to get some dash/interior pieces painted this weekend
save me some stress.....

 

I'm the one that was wondering this info... thanks a lot kelspar

 

Moved to it's proper place

 

i think pics should be mandatory for all "how to" threads.

 

Ok ill post pics when i get my cam back from friend.......should be in by the end of this weekend......

 

Moving to show and shine, copying to install forum and closing.

 

Thanks for the info, Kelspar. I had to remove my center console to install an inline tap to the cigarette lighter power cable. My Valentine One is now hard-wired into my new Evo.