2015 Lancer 2.4 Mivec, hooked ECUflash 1.44 up to it with an OP2.0, read the Ecu, it said error occurred and then the cars rad fans came on, and messages service acs system, engine system service required, and engine overheating. And it wont start. Tried using exit programming mode in ECuflash and no change. Ideas?

 

ECU is stuck in boot mode contact Tactrix ASAP. I got your PM I responded.

 

yeah thanks again. I'll post up whatever results I come up with

 

Well I couldnt figure anything out before my wife decided she just wanted it towed, so it is at the dealership and probably wont be looked at until at least mid day tomorrow. Ill post back when we hear from them.

 

Well nothing yet, but the dealer called today to ask how long there have been HIDs installed in the car (over a year) and if they could unplug them because they think thats what caused the ECU to lock up......I wish they could see my look of pure befuddlement as to why in the blue hell headlights can cause an ECU problem......Not sure how this is going to go.

 

Got the car back tonight, they put in a new ECU and thankfully everything was covered under warranty. I think Ill stick to modifying the Evo and leave the Lancer alone from now on.