Magnecor plug wires for your Lancer !!!
Magnecor plug wires for your Lancer !!!
Magnecor 8mm and 8.5mm spark plug wires - FREE SHIPPING !!
There are two models avaialable for our Lancers. The 8mm comes in blue and the 8.5mm comes in red. The 8mm will be $72 shipped to the continental USA and the 8.5mm will be $90.99 shipped to the continental USA......
Here are the descriptions of each to better help yoou decide which one is for your application !
Magnecor 8mm Electrosports 80 Ignition Cables
Original equipment replacement. Designed to improve original ignition system performance on street vehicles using either electronic engine management systems or carburetors. Conductor provides excellent RFI and EMI suppression to permanently eliminate the typical performance and fuel-wasting spark energy deterioration of OE and aftermarket carbon conductor wires. Also overcomes performance problems associated with poorly suppressed aftermarket spiral conductor wires on both modern and older engines. The conventional style insulating jacket consists of high dielectric strength silicone rubber insulation, fiberglass reinforcing braiding and a high temperature, high tear strength silicone rubber outer jacket. The flexibility and ruggedness of the cable allows it to be fitted into original 7mm cable holders. Ideal for use on heat-generating LPG (propane) gas conversion engines.
KV85 Competition (8.5mm)
These 8.5mm Ignition Cables feature Magnecor's exclusive 2.5mm high capacity Metallic Inductance EMI Suppressed conductor consisting of stainless steel wire precisely wound at 200 turns per inch over a ferrimagnetic core. The insulating jacket is made entirely of Magnecor's exclusive TC-1500-HS high strength aerospace grade silicone rubber, and its single layer construction will prolong the jacket's insulating ability by conducting extreme heat away from hot-spots that occur near over-the-limit heat sources. The KV85 8.5mm jacket has a service heat resistance of 600 degrees F (320 degrees C) and up to 1,000 degrees F (540 degrees C) for short burst 3 minutes.
This is a pic of the 8mm (blue) !
There are two models avaialable for our Lancers. The 8mm comes in blue and the 8.5mm comes in red. The 8mm will be $72 shipped to the continental USA and the 8.5mm will be $90.99 shipped to the continental USA......
Here are the descriptions of each to better help yoou decide which one is for your application !
Magnecor 8mm Electrosports 80 Ignition Cables
Original equipment replacement. Designed to improve original ignition system performance on street vehicles using either electronic engine management systems or carburetors. Conductor provides excellent RFI and EMI suppression to permanently eliminate the typical performance and fuel-wasting spark energy deterioration of OE and aftermarket carbon conductor wires. Also overcomes performance problems associated with poorly suppressed aftermarket spiral conductor wires on both modern and older engines. The conventional style insulating jacket consists of high dielectric strength silicone rubber insulation, fiberglass reinforcing braiding and a high temperature, high tear strength silicone rubber outer jacket. The flexibility and ruggedness of the cable allows it to be fitted into original 7mm cable holders. Ideal for use on heat-generating LPG (propane) gas conversion engines.
KV85 Competition (8.5mm)
These 8.5mm Ignition Cables feature Magnecor's exclusive 2.5mm high capacity Metallic Inductance EMI Suppressed conductor consisting of stainless steel wire precisely wound at 200 turns per inch over a ferrimagnetic core. The insulating jacket is made entirely of Magnecor's exclusive TC-1500-HS high strength aerospace grade silicone rubber, and its single layer construction will prolong the jacket's insulating ability by conducting extreme heat away from hot-spots that occur near over-the-limit heat sources. The KV85 8.5mm jacket has a service heat resistance of 600 degrees F (320 degrees C) and up to 1,000 degrees F (540 degrees C) for short burst 3 minutes.
This is a pic of the 8mm (blue) !
Last edited by DRC Imports; Aug 2, 2003 at 08:17 AM.
i would rather have the blue for looks.... but I don't get it. The blue one is for engines running an EMS??? Can I use it, or do I have to get the 8.5 because I don't have an ems?
Get the 8mm if you don't have alot of aftermarket electronics and are naturally aspirated with few mods such as simple bolt ons like intake,exhaust, throttle body. These are some of the mods I have and ordered 8mm
Trending Topics
Originally posted by Guru_Del
on NA the best result I have seen is it smooths out idle and nets a little better gas mileage
on NA the best result I have seen is it smooths out idle and nets a little better gas mileage
This deal is my everyday price for evom members !
Last edited by DRC Imports; Jul 30, 2003 at 03:55 PM.
i mite grab one from u when i've the ca$h, since urs cost a little less than RRM...
I like red, but I dun have any engine mods, u only have 8mm in blue?
btw, oz, what's ur price for aem cai now?
for '03 OZ...
I like red, but I dun have any engine mods, u only have 8mm in blue?
btw, oz, what's ur price for aem cai now?
for '03 OZ...
Originally posted by ozrallyguy
and condicts a more accurate charge(spark) !!
and condicts a more accurate charge(spark) !!
Originally posted by drummerjun
i mite grab one from u when i've the ca$h, since urs cost a little less than RRM...
I like red, but I dun have any engine mods, u only have 8mm in blue?
btw, oz, what's ur price for aem cai now?
for '03 OZ...
i mite grab one from u when i've the ca$h, since urs cost a little less than RRM...
I like red, but I dun have any engine mods, u only have 8mm in blue?
btw, oz, what's ur price for aem cai now?
for '03 OZ...
your price is better than RRM with shipping, but I live close to RRM so I can always just do a pick-up..
sorry for cluttering up your thread.
will PM you when I need anything!

EDIT: still no Ralliart Grille?
sorry for cluttering up your thread.
will PM you when I need anything!
EDIT: still no Ralliart Grille?


