I'd like to swap my 5sp trim for the MR's. I do not want the ashtray, so I only need the console cover and shift boot. I'm going to make my own sticker.

Does the shift boot come attached to the plastic ring that screws into the console cover?


So, it looks like I only need...

6 Speed M/T Console Trim

Gearshift Lever Cover (Shift Boot)
Gearshift Lever Panel



What are these for?

Gearshift Lever Cover Screws




Thank you ahead of time.

 

there is no ring on the 6 speed cover and the boot is differnt as it snaps/wont fit on the 5 speed lever unless you like seeing your silver rod and the 5spd boot is too small for the 6 speed covers hole. Its also not a "sticker" its actually part of the cover itself with like a clear gel coating over it.

 

Slow down, killer. Don't be afraid of the comma's!!!


Thanks for the input. Is that small piece at the top of the boot (on 6sp) actually part of the boot? Is this what you're referring to?



So bottom line, it can't be done?

 

The "MR" decal that goes on the console behind the shifter is sold separately. I will post up the part numbers you are after in the morning.

 

Here is a link and a break down of all the parts. Im also still doing free ground shipping through the end of the month.


Shifter Boot - MN124950XA
"MR" Badge For Console - 8011A017
Gearshift Panel - 8015A001HA
Screws - MB409435 (qty. 5)

http://www.mitsubishiparts.net/cart/...5*5+MN124950XA

 

Wanted to thank you for putting it all in one easy post for me. Just placed my order.

(my panel is scratched)

thanks
john

 

No problem! This post was awaken from the dead!

 

Russ is a good guy'

Superior cust service.