Hey guys...just wanted to share my Evo race car project. My Evo7 has been my trackday car for years now, and its come to a point where it is not street friendly anymore, and yet still a compromise as a trackday car. Finally after months and months of the car just sitting in the garage, I finally decided to make it an all out trackcar. Of course due to budget constraints, I will have to take this car one step at a time. First step is safety and chasis preparation, by seamwelding and putting in a welded cage.

Comments and Suggestions are welcome.

Here is a picture of the car some time ago in my local track:



This is what the car looked like a few days after dropping it off at the shop:





After getting seamwelded:









Starting with the cage:







Test Fitting the Seat:



Assembling the car back:

Amazing that they didn't even have to cut the dashboard...





One manpower car



Almost done:

 

ahhh looking good

 

the shop did a great job. like how flush the cage is

 

Huge job done! Great evo’s! Now just have fun with them

 

If I were to do it again for a race car I'd deff dip/blast/weld/prime it too.