can't wait to see this rocker cover

 

That thing is a beast!

 

Well another piece of the puzzle showed up today.

Thanks Fathouse Fab for making my new catch can! I'll get install pics the minute it goes on the car. Maybe tomorrow if I get bored

 

Man Chris lots of new go fast goodies going in the car for this season

GL reaching your goal of the 8sec pass i know you've been working hard to get it!

Thanks for all the pics/updates.....for some reason i'm diggin those hydro-dipped wheels i wonder if it would be lame looking to have the slipstreams done like that??? Is that process expensive?

 

FatHouse does some clean work very nice man

 

Ya I thought about doing my rims too haha. It looks badass

I'm not sure on the cost. Contact Tirado they will hook you up. They do great work.

 

Update 4.10.2013


Well just got back from Buschur. Came home with my freshly re-worked shortblock and new v-band forward facing manifold and dumptube. Looks like I should have all my other parts finished up by next Wednesday. As of now I am right on track to have the car finished up by the Buschur spring race at the end of May.

The shorblock got all new bearings, JE pistons, rings, OEM crank, ARP mains, bored .020 over, decked, and ss o-ringed. The GRP aluminum rods that have seen two full seasons were checked and are good to go.





The new Buschur forward facing v-band manifold looks great. I am sending all my hot parts out to Tirado to get ceramic coated.




I will start to put the motor back into the car next week. Right now I have my engine harness all torn apart again to remove the two connectors not being used anymore now that I will no longer have MIVEC. It is a lot of work just for two connectors but I don't care...I want them gone haha. I am also going to be moving my ignition wires to a completely seperate harness. I want to seperate it from all other wires running into the car. The new harness will enter the engine bay behind my re-located power steering pump reservoir.

More pics and updates to come

 

Very nice top dollar parts right there! This car is going to fly this year hope i get a chance to see it in person this year!

 

love the ff manifold there mate.

 

I can not wait to see this beast run. Its looking great.

 

Looking good man.
Did you end up modifying anything on the head for the oring? I know some "groove" the head

 

Coming together Chris! Can't wait to see her boogie at the IDRC.

 

No I believe the cylinder head will just be milled flat. I pick up my BR stage 3 cylinder head this coming Wednesday.

 

Ok just asking because I see some people modify the head for the block oring.

 

Bored....so I finally got around to posting an alternative view from my GoPro of my 9.3 pass from last year.