SOLD

Intake located in Charlotte, NC and is SOLD shipped Cont. US. I paid $500 shipped for this unit new and has less than 2000miles.

I have gone to a new intake setup so I am selling the Skunk2 intake manifold. I have made the necessary mods to this intake so it is ready to run. It comes with the dipstick tube, but not the fuel rail spacers. Those spacers where not the correct thickness so you run the stock ones and sand down one side(see pic below).

Mods as follows:
- Cleaned/matched ports
- Secured the freezeplug with bolts
- fitting aligned for stock BOV tube
- aftermarket fitting/hose provided for valve cover PCV
- custom waterjet cut flange for running stock/65mm stock throttle body
- correct length bolts for TB
- gaskets for TB
- hole drilled tapped for ground wire provision
- throttle cable/dipstick bolts

 

Someone should test this against a map rev 3

 

bump

 

why don't you wanna keep it? i was interesting in buying a DI or Magnus V5

 

I purchased a new motor so I am making a bunch of changes, which include ECU, Turbo, Intake, Exhaust, ignition and a few other goodies.

 

Sold