Hey everyone i have 22 to 27 fault codes that only show up after 100+ kms of driving. They don't effect the performance or idle of the car, not sure why they come up

If anyone has gotten them before please chime in

Used motor just recently put in

Evo X 20 swap
AMS Intake
3 inch turbo back( ur dp, depo hfc, magnaflow cb.
Grimmspeed ebcs
X bpv
Stock injectors
Stock fuel pump
X ic( injen uicp)
Aem failsafe wideband/boost gauge

 

Golly. Since you have network codes id think a wrong ecu was used.

Most of those codes usually have performance issues.

 

It's a stock ecu
My car is 2010
Engine put in was an 09
But same engine harness for my 2010
Timing chain off my 2010 was used because the 09 is v1.
The tune I have on right now was flashed via tephra mod v1.
So I'm at a loss as to why they are popping up. And a majority of them are emission codes

 

Anyone have any insight? As to what would cause these codes

 

Check all your grounds. It sounds like you might be missing an engine-to-chassis ground somewhere.

 

all grounds look connected

 

As was stated, you have CAN network codes. ECU is likely smoked.