Low load knock (SST) - need opinion
#1
Evolving Member
Thread Starter
Low load knock (SST) - need opinion
Hi, I have 2008 JDM MR with tephra v3 and have been datalogging actively with Evoscan and Torque (with MUT2). I could not get rid of low load knock when I drove in auto mode, especially at D6 (gear 6) and you gently tap on throttle and my CEL flash like mad (CEL on knock).
The car will hesitate to go forward until I step 50% more throttle to get over it. This happen on load below 100, timing is pulled, Octane drop. I tried changing different gas, less aggressive timing and mivec timing, it doesn't help. Here's 3 screenshot of logs that support this.
I don't get any knock during WOT and if I drive with manual mode, I seldom encounter low load knocks.
Any clue?
The car will hesitate to go forward until I step 50% more throttle to get over it. This happen on load below 100, timing is pulled, Octane drop. I tried changing different gas, less aggressive timing and mivec timing, it doesn't help. Here's 3 screenshot of logs that support this.
I don't get any knock during WOT and if I drive with manual mode, I seldom encounter low load knocks.
Any clue?
Thread
Thread Starter
Forum
Replies
Last Post
thedru13
Evo Engine / Turbo / Drivetrain
3
Nov 3, 2014 08:58 AM
Clipse3GT
Mitsubishi TC-SST Discussion
2
Jun 15, 2010 09:33 AM