The IFS-10 can be installed such that it enables the BBK-10 solenoid to limit boost to WG pressure until your meth starts flowing. Once meth is flowing, the BBK shuts off and allows boost to go up. So no meth, no boost past waste gate.

The IFS has an internal flow meter and monitors the meth flow in real time. It also has an over flow limit in the event a hose is loose.

The AEM uses the same fluid line as our system. Just cut the line from your pump to the nozzle and plug line into the IFS.

The Flow Gauges are an optional device. The IFS outputs a 0-5v signal proportional to flow. Our gauges read this signal and show the flow rate in mL/min.

 

im sorry, but i still dont understand. whats the whole point of getting this item along with a meth kit? its not about the money or anything. im just trying to see if theres a point of getting it or not.

Thanks!

 

im going to bump this thread. im running the largest meth nozzle on the AEM kit and would like to run a bigger nozzle. anyone help me out finding a new nozzle? or should i run a splitter and 2 nozzles?