Scaling needed for aem 3.5 bar map
#1
Evolved Member
Thread Starter
iTrader: (65)
Join Date: Oct 2007
Location: New Oxford, Pa
Posts: 723
Likes: 0
Received 0 Likes
on
0 Posts
Scaling needed for aem 3.5 bar map
Hey guys- I just converted a car back to stock ecu and am attempting to use the 3.5 bar map sensor that the aem was using. Does anyone have the map scaling for the 3.5 bar sensor? It is the same for the kevlico and ssi sensors if that helps.
Thanks in advance
Grant
Thanks in advance
Grant
#2
Evolved Member
Thread Starter
iTrader: (65)
Join Date: Oct 2007
Location: New Oxford, Pa
Posts: 723
Likes: 0
Received 0 Likes
on
0 Posts
I have a chart showing voltage to kpa for the 3.5 bar but....
Upon further research I compared the chart on the aem 5 bar to what people are using in ecu flash and it is completely off of the settings people are using. Is there an offset or do I have to account for atmospheric pressure.
I am assuming the units side of the scale correlates to kpa but maybe I am wrong.
Upon further research I compared the chart on the aem 5 bar to what people are using in ecu flash and it is completely off of the settings people are using. Is there an offset or do I have to account for atmospheric pressure.
I am assuming the units side of the scale correlates to kpa but maybe I am wrong.
Thread
Thread Starter
Forum
Replies
Last Post
mrfred
ECU Flash
268
Feb 26, 2022 06:16 PM