Evo How To Requests / Questions / TipsIf you're looking for a how-to on something, ask in here.
Welcome to EvolutionM.net!
Welcome to EvolutionM.net.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
i am putting my stock trunk lid back on my car however i dont know how the two pieces go in. pls help if you know what im taliking about. i believe that they cross one another. without them installed the trunk doesnt go up when the latch is pulled.
Last edited by evolution5690; Apr 17, 2011 at 04:55 PM.
Find the post where the moderator posts a schematic of which one goes on which side (they aren't the same). Once you do that use a standard sized hammer handle to crank the torsion bar back into place, you should be careful though because this requires a bit of force and can snap back at you if the hammer comes loose.