where on your plenum are you taking your map sensor measurement reading?

how long is your line length if using line?

is your plenum oem or aftemarket?

 

We use a billet aluminum map sensor mount in our cars/kits here. The mount takes the place of the factory map sensor and lets you put the AEM threaded sensor in it's place. Works the best as far as I am concerned. No hoses to blow off, o-ring seal.

 

Buschur has a very good set up be careful and lube the o-ring before putting it in. I cut the o-ring when installing mine

 

+1 for the BR adaptor. Have it, love it, made the install easy. You will read posts about it being close to the strut bar but it will never hit. Those people that say that have never installed/used it.

 

I like the RRE setup. It's in the same location as the Buschur, but puts the sensor at a 90* angle so it looks better and doesn't get in the way of aftermarket strut bars.

http://www.roadraceengineering.com/p...r/IMG_1310.JPG

http://www.roadraceengineering.com/ems.htm

 

Thanks guy's

 

Research and copy...............the way of the import world.

Ours doesn't even come close to the strut tower bar there is no issue with that no matter who's bar you use.

 

i have the switzer one in the stock map sensor location.. i'm sure it's just like the rre peice or buschur's..