Hi, I installed a AEM 5 bar map sensor on a car and I can't change the map min volts to any number that has decimals.

If I enter "0" or "1" it works. But I cannot enter i.e. "0.5" volts. Is this normal ? Where and how to change the map min volt value?

 

aempro/set-up/sensors/manifold pressure sensor/map sensor wizard

select your sensor from there & that will configure the proper sensor for you.

but if you need to change the voltages for what ever reason.....

aempro/set-up/sensors/manifold pressure sensor/options-Map sensor