26.5 front, 26 rear.
Full soft both front and rear. Instructed by Mike at AWD Motorsports to leave it full soft for drag.

 

Now is that from the ground to the fender?
thanks

 

Ground to the top of the fender, in the middle.

 

what spacers are everbody using ?

 

For the Rota wheels, Ebay 22mm spacers for the front. Rear spacers are optional. Link to buy them is one of the previous posts above.

Spacer studs were removed since I'm using ARP 3" studs so the spacers are pass through.

 

You should measure ride height from the center axle to the fender... it's a little more accurate and repeatable measurement.

 

Cool thanks

 

Do you need innertubes with these tires? Thanks!

 

No.

 

Rims, Tires, and spacers are for sale!

https://www.evolutionm.net/forums/ve...ml#post9560870

Devin

 

Im to slow Devin lol. I think I might have to rock this setup next year

 

Thanks for the rims and tires devin!

 

I'm about to sell my QTP Rota setup as well but I see that everyone are using the fugly slipstreams... Is that because the Rota Grids wont fit with the spacers? Mine are the Grids so I figure I might as well make sure before I bother posting them up FS.

Thanks.

 

Size for size, Grids are heavier.

16x7 Rota Slipstreams = 13.5lb
16x7 Rota R-spec = 14.5
16x7 Rota Subzero = 14.5
16x7 Rota Grid = 15 lbs
16x7 Rota Circuit 8 = 15.5
16x7 Rota GT3's = 17 lbs
16x7 Rota MSR = 17.2

 

I just weighed my Grids in at 14.2lbs at my house since I'm shipping a set took em to the shipping place and they weighed em out at 14.1lbs 15 sounds high for the 16X7s...

All 4 wheels weighed out within a few tenths.