Silly idea to log boost in EvoScan??
EvoM Guru
iTrader: (50)
Joined: Mar 2006
Posts: 9,675
Likes: 132
From: Tri-Cities, WA // Portland, OR
Can you post the subroutine names for this code and I'll see if i can find this for my JDM Evo7. From some of the snipits jcsbanks has posted, it looks like some of the routines may share the same names between ROMs. To be honest I'm not to hopeful of being able to do this ( realload anyone? ) but I'd like to give it a try.
MB
MB
Very nice to see that this is working 
But like some here I also have an EVO 8.
MB: how would you go about looking for the subroutine names ? could that be done in a rom read from an ECU ?
Gudmundur

But like some here I also have an EVO 8.
MB: how would you go about looking for the subroutine names ? could that be done in a rom read from an ECU ?
Gudmundur
EvoM Guru
iTrader: (50)
Joined: Mar 2006
Posts: 9,675
Likes: 132
From: Tri-Cities, WA // Portland, OR
Can you post the subroutine names for this code and I'll see if i can find this for my JDM Evo7. From some of the snipits jcsbanks has posted, it looks like some of the routines may share the same names between ROMs. To be honest I'm not to hopeful of being able to do this ( realload anyone? ) but I'd like to give it a try.
MB
MB
http://www.aktivematrix.com/forum/viewtopic.php?t=183
Thanks 
P.S. Easier idea to put map sensor to unused ecu ADC input
ECU unused PIN ;MUT REQUEST
74 ; 0x88
77 ;0x87
One of above pins has internall ~5v pullup -the other doesn't.
0x3C is the request for the rear o2 sensor. PROVEN.
5v signal is OK.
Linear calibration 0V-0 ;5v around 255;
Several patches using analog inputs are already ready
Map controlled ecu patch under test (working).
Knock light patch working on my evo7 ra ecu.
Analog maps interpolating patch working.

P.S. Easier idea to put map sensor to unused ecu ADC input
ECU unused PIN ;MUT REQUEST
74 ; 0x88
77 ;0x87
One of above pins has internall ~5v pullup -the other doesn't.
0x3C is the request for the rear o2 sensor. PROVEN.
5v signal is OK.
Linear calibration 0V-0 ;5v around 255;
Several patches using analog inputs are already ready

Map controlled ecu patch under test (working).
Knock light patch working on my evo7 ra ecu.
Analog maps interpolating patch working.
This EcuFlash forum is starting to remind me of the old school national DSM list where everyone was helping each other find and figure out stuff.
It's a good time to be a EVO owner.
It's a good time to be a EVO owner.







