roms and tephra patch
#22
Evolved Member
Thread Starter
yes it turns over, the cel flashes fast for 5secs then a very brief pause then flashes again for 5secs then goes off
.
for breakfast
.
Last edited by leecavturbo; Jul 19, 2008 at 01:30 PM.
#24
Evolved Member
Thread Starter
i copied it from my stock rom to the 96530006.
i did not make any xml changes to do with immobiliser!
however when i copied your mods from 5.1xml and pasted them into
the 96530006 xml some of the text was not aligned with the majority of it
so i tabbed the ones that wasn't aligned!
i did not make any xml changes to do with immobiliser!
however when i copied your mods from 5.1xml and pasted them into
the 96530006 xml some of the text was not aligned with the majority of it
so i tabbed the ones that wasn't aligned!
Last edited by leecavturbo; Jul 19, 2008 at 10:34 PM.
#27
Evolved Member
Thread Starter
#28
Evolving Member
iTrader: (1)
Join Date: Dec 2006
Location: UK
Posts: 141
Likes: 0
Received 0 Likes
on
0 Posts
Add this line into the xml file you wish to use <table name="(periphery 0)" category="Misc" address="faa" type="1D" level="1" scaling="Hex16"/>
and then change the value to 56d0 which is no immobilser and no rear o2 the stock hex is 56d8 which is no rear o2 as we dont have rear o2 sensors on the jdm cars.
and then change the value to 56d0 which is no immobilser and no rear o2 the stock hex is 56d8 which is no rear o2 as we dont have rear o2 sensors on the jdm cars.
#29
Evolved Member
Thread Starter
made the xml change.
opened the rom and the hex values will not change, yes i clicked set data or equals button a box pops up you press enter after entering your value.
but the hex does not show a change?
.
opened the rom and the hex values will not change, yes i clicked set data or equals button a box pops up you press enter after entering your value.
but the hex does not show a change?
.
Last edited by leecavturbo; Jul 20, 2008 at 01:01 PM.