Can someone provide the addresses for Lean spool start/stop for 94170015?

For that matter does anyone want to share their xml from their 94170015 or 14? Once I finish mine I will share. It will contain lean spool, JDM Map, etc.

 

<table name="Lean Spool Start RPM" category="Fuel" address="1680" type="1D" level="1" scaling="RPMStatLimit"/>

<table name="Lean Spool Stop RPM" category="Fuel" address="1684" type="1D" level="1" scaling="RPMStatLimit"/>

Paste that into your evo7base.xml

 

Whats there to share, isn't it provided with ECUflash?

 

There are a few errors in the xml.

 

Oh, ok

 

in version 1.35? where? and the lean spool addy's are already there

 

OK Ace. I stand corrected...Guess I will not be sharing. Probably easier this way.

 

Hmmmm not sure if that was meant in a less than positive tone, but I wasn't trying to be cheeky myself. I really was serious, if you found errors I wanted to know where so I could change them in mine.

 

The default lean spool disable is wrong on Evo9base.xml in 1.35, it might be for others as well.

 

I am just wary of posting modded xml for those who do not know what they are doing. I don't want to be responsible for peoples engines.

 

chmodlf oh you won't be responsible. it is their responsibility. It isn't like this stuff isn't already posted on EvoM, yours would just be another source. There is plenty of info, especially in the wiki, to guide people to making the mods they need.

I do feel ya that you don't want to lead people astray, but corrections to errors should most certainly be posted. Consider that more damage could be done by an incorrect value correctly used, than a correct value incorrectly used.

PessimiStick ahh fair enough. As far as I can tell it is right in 1.35 for 94170015 based on my experience. No doubt my fuel got WAY richer by changing the table values for Lean Spool Start/Stop

EDIT: PS ... a modded XML can't hurt a persons car in and of itself unless they go ahead and use that definition to modify the value in the ROM ... so really posting a modded xml is as benign as anything else we've posted on this board that could grenade someone's motor.

 

how would i go about disabling lean spool altogether?...and im at a loss, my lean spool start is at 3200 and stop is at 1250, does that make sense??? any help is much appreciated

 

The general way to disable it is to set the start and stop RPMs to the same value. I think mine are at 1250 or something, though I'm not sure the actual number matters. (But lower is probably better, in case it were to spike lean for a second before it checked to disable or somesuch.)