It's alive! (Speed density, stock ECU)
Thread Starter
Account Disabled
iTrader: (1)
Joined: Jun 2006
Posts: 472
Likes: 0
From: Taftville, CT
It's alive! (Speed density, stock ECU)
http://www.youtube.com/watch?v=VIBVflLvLr8
Where's meh MAF sensOr?!?!
As soon as the paint/body is done, I'll be doing the clutch break in and then el dyno. Results to come!
Where's meh MAF sensOr?!?!
As soon as the paint/body is done, I'll be doing the clutch break in and then el dyno. Results to come!
Thread Starter
Account Disabled
iTrader: (1)
Joined: Jun 2006
Posts: 472
Likes: 0
From: Taftville, CT
What details do you want? Basically, I am using a JDM MAP sensor and GM AIT sensor to measure air flow instead of the stock MAF. My ROM is patched to do all the calculations and to disable any CEL associated with removing the MAF sensor. The only physical modifications required to do this is to wire the GM AIT sensor into the ECU in place of the stock sensor signal lead. Then use a 1kOhm resistor in place of the baro sensor. Finally, swap in a JDM MAP sensor. I'm trying to get someone to look at my ROM and see about porting the patch over to other ROM ID's.
Trending Topics
Thread Starter
Account Disabled
iTrader: (1)
Joined: Jun 2006
Posts: 472
Likes: 0
From: Taftville, CT
Yeah, Bez did an awesome job with the patch. Unfortunately. he is out in a jungle somewhere, miles away from civilization. I don't know when I will hear back from him with a new improved version with source code for me to test.
Evolved Member
Joined: May 2006
Posts: 2,399
Likes: 6
From: UK
mixmastermatt, can you post up your ROM and info, plus the base ROM that was used to do the modification? I know you are 88590015, but I wanted to do a compare.
I know you did this before but there are probably further changes in your latest?
I know you did this before but there are probably further changes in your latest?