Without the error message(s) no one can begin to figure out what your problem is.

 

solved the error message went in ecuflash and changed the newly created table ignition reatrd limit to -20 i should just try it right now it should work

 

did everything and flashed the car but im not seeing less then -10 timing is there anything else then writing the tables and the scaling?

 

did you put in these

<scaling name="TimingMUT" units="degrees" toexpr="x-20" frexpr="x+20" format="%.0f" min="-20" max="60" inc="1" storagetype="uint8" endian="big" />

<table name="Ignition Retard Limit" address="1813d" category="Timing" type="1D" level="2" scaling="TimingMUT" />
<table name="Ignition Advance Limit" address="1813f" category="Timing" type="1D" level="2" scaling="TimingMUT" />

 

e mail me rom and xml il take a look

 

yeah i have put in these whats your email address ?

 

You've put both retard limits to -20?

 

what do you mean by both in ecuflash i have only set ignition retard limit to -20 and in my high oct ignition map i have put -20 is there something else i should do ?

 

email sent thanks for the help

 

what do you mean by both retard limits in xml file or in my rom in ecuflash?

 

If you've added the new retard limits as above your XML should now have at least two retard limits showing in ECUFlash and both need to be set to -20 deg, depending on the scaling. Setting up new maps in ECUFlash can sometimes be a little tricky and it sounds like you haven't got the retard limits defined correctly, but Todd will sort you out, he knows what he's doing.

 

yeah im in contact with him he sent my a file didnt have the time to try it yet tomorrow for sure

 

I had something weird happen,, when I was messing with the launch maps
I adjusted both the retard limits and also added - timing to the the launch map
(nlts was on) So I was at the drag strip and 1-2 nlts was fine but as soon as got into 3rd gear the car fell on its face,,, no boost felt like if I went from 1st-like 5th gear,,,

 

it may be clutch button issue, i had same problem on a customer car.

 

I don't believe its the switch .. because when I out the retard settings back to 203..
it didn't do it again..