bump for help, my wgdc change stays at 0 and -3.087 for boost error correction...

 

request id 8a 0.0241*x-3.087 (boost error)

request id 8b 0.5*x-64 ( wgdc correction)


is this right?

 

i think i found the issue the left side of the BEC and TBEC aren't matched up...i know the tbec is -20 to 20 and the bec is -3 to 3..but thats not what i'm seeing...and i checked the xml and its exactly whats listed so i'm not sure whats being mis calculated.

 

ok so now here is where i am.

i was able to get the left side of BEC and TBEC to show correctly by changing the endian to big on the boosterrorpsi..which i searched and finally found!!...

however, still my evoscan reads -3.081 across the board on my boost error, and my wgdc% stays at 0..

when i get home i will post up my tables so you can see my boost adder is 14.7 and Baseline boost is set at 24.6...now my jdm map is readin around these numbers because i basically been tuning off the wgdc...however I want my error correction to start functioning right.

 

bump, someone has to know the fix to this....ps rom is evo 8 94170008

 

ok i think i may have fixed, but need to test...turns out i had to change the endian to "big"....but it wasn't shown in my room..had to read above to find that one out....but anywho...gonna test in a couple hours to see if this resolves it..hopefully it does.

 

resolved

 

do you get any stutter under light driving when you lift foot off the throttle?

lets say when under 3 psi boost? open or closed loop.

 

yes, i do actually