I think that's about normal. You need to increase the Boost Adder (PSI) value.

 

Yup so as long as you use the proper equation you are fine:

Boost Adder + Boost Desired Engine 'PSI' Table - Your atmospheric (baro) = your target boost.

So lets say you want 29.3 psi targeted and you can't go above 24.6.

An example would be

20 (boost adder) + 24 (Boost desired) = 44 - 14.7 = 29.3 psi

 

<3 the pretty picture

You can also log Boost Error in Evoscan as another way to see if your tables are set correctly. WHen you hit your desired boost, boost error should be ~0.

 

whats the diff between

Boost Desired Engine PSI (withs gears 1-6)
vs
Base Boost (High Gear Range)
Base Boost (Low Gear Range)

cuz i have all three..

i rather use the one with all gears shown but both styles dont reflect each other.

which does the ECU take into use??

 

CRON - It sounds like the XML for your 88590715 ROM is pretty messed up. There are no tables called Base Boost in v7. Perhaps you should re-download and check you have the right XML before going further.

A better thread to post your v7 setup issues would be the TephraMod V7
thread here....https://www.evolutionm.net/forums/ec...od-v7-185.html