211Ratsbud

iTrader: (1)

p0505 idle system control malfunction, running and driving on 8858071x

donner

iTrader: (1)

Have you done base idle setting by setting stepper to base position with evoscan and setting idle speed by by-pass screw? Also monitor your ISC steps.

211Ratsbud

iTrader: (1)

negative, I am on a full blown 70mm throttle body with no screw. s2 cams aswell... is there a range of steps that it must be around at idle or CEL>? or my tps reads 16% at idle.. too high?

211Ratsbud

iTrader: (1)

3ish psi on decel. Maybe less, or more analog gauge is poopy.

Havent done any fuel tuning yet and using an old ign map from my fp white/ 272 hks setup. Need to sort out some final hookups. The 0505 code is seemingly from the 8858 rom.

That appears to be the only code though. can i disable this code from the periphery?

foxbat

3! are you serious?? not bad for starter! Even a 0 would be a good start! Have u set up all ALS table.. + negative timing?

211Ratsbud

iTrader: (1)

Well i need to come up with a way to log boost in the uicp. Thinkin of another map sensor and adc input.

Thats with -20 and aor fuel injection

211Ratsbud

iTrader: (1)

My sas cold side plumbing is leaking boost and !my dynomax vt needs to go

211Ratsbud

iTrader: (1)

Ordered two ets couplers for recirculating bpv. Ater work today the truck shop said they could fix me up a tube that goes into the iat bung roughly 3/4" dia and goes to the sas valve. So hopefully i can get this sorted out for my first solo event of this season .. as soon as this gets rockin i will video.


Foxbat, there are roms to control this for evo 7, 8,9 but im not sure of previous, i would not hesitate to give -10 a try. Also ceddy rom can do like -26 right?

Maikumaru

Ratsbud
Do you have a pic where you T ed into on the compressor to measure boost?

I want to give your way a try.

211Ratsbud

iTrader: (1)

I just used a brass t on my compressor ref line to my boost solenoid .. no pic i took it off already

foxbat

True, ALS tables are available for evo 5 through 9, Ceddy's (evo 5/6) is capable of -27, so, I'm eager to try it on my 6

What value did you end up using for 'load below which active'?

211Ratsbud

iTrader: (1)

I havent fiddled with that yet, still set at 80

211Ratsbud

iTrader: (1)

Alrighty, altmap was working for a while then it just stopped. I havent checked to see if tps worked.

Maikumaru

were you using map switch?

I have not gotten map switch to work with SAS...what you briefly described happens to me...

switch it to other map...does not switch immediately but like 30 min after...really strange

211Ratsbud

iTrader: (1)

Mine was working fine with map switch. But it stopped.

Anways my new sas supply line consist of a garden hose 3/4 barb, on an adapter to 1/2 npt. Then a flexible hose to my sas valve