hello guys just installed evoscan recently and im knew to using it my car evo 8 has aem uego afr gauge which I think already has white wire connected to pin 75 my problem is when editing the Eval and putting 0.03913*x+9 im not getting accurate afr with my gauge my gauge is at 15 and logged afr is 10 if I increase equation to x+15 afr becomes close but when my gauge drops to 14 my logged jumps to 16


Another problem whit my Omni 4 bar map sensor which is not calibrated in evoscan when I insert the eval and metric eval shown in previous threads around here
I get evoscan error RAX_DAT_D MUST preceed boost (map) move RAX_DAT_D TO above boost(Map)
anyhelp would be greatly appreciated

 

bumppp anyone can help please ??

 

I would start off by confirming this.

Have you tried uninstalling Evoscan and re-installing it with 4bar values? Sometimes weird **** just happens in evoscan.

Also, through up a log.

 

You should just buy a serial port adapter and log afr through it

 

Are you using the rear o2 sim?

For you map sensor issue, post the formula and a screen shot of your ecuflash data items. Looks like it's expecting some value to be present before the MAP value is computed? I'm not sure

 

i attached 3 logs of wot pulls 4 BAR map sensor and afr are at right end of the page with values way off will confirm pin 75 connection tomorrow

 

where can I buy it and what does it actually do

 

the eval im using is 0.2369*x with psig as unit you check my logs if you don't mind

 

Please look at this.

 

thanks man ill try this equation and see what happens

 

the omni equation worked with -24.7 instead of 14.7
But still facing issues logging afr equation didnt worked should look to see if connection to pin 75 is already made

 

Try Pin 73

 

While searching ive found this connector with 2 black and bkue wire is that supposed to be a serial port connection for the afr?its right under the dash

 

Yes. That is a serial port. God only knows what those wires are connected to though. You need to trace them back to whatever they are connected to.

 

Yea thats a serial port. Figure out were those wires go.
Your gonna need to buy a belkin serial to usb converter also