Ok I would try just logging while the car is running next.. use evoscan or mitsulogger. If that works then you know there is no problem with the openport 2.0 ..

Based on your photos should be set correctly.. possibly your re flash connector is a bad connection?

The error is basically saying no response from car ECU is my understanding

 

Tried logging with mitsulogger and the status window says no device detected. Cant get through evoscan, are they still in business?

 

It sounds like your problem is the tactrix device (drivers?

Are you using a genuine device?

Complete reinstall?

 

Yeap bought directly from tactrix, i emailed them about the problem but no reply yet. Will try reinstall later, someone suggest to conect the tactrix and let the driver install before installing the openport?

 

Yes I would try that. You should be able to see it in your device manger once installed.

 

This has happened to me quite a few times with Airtreks.

Usually solved by:
1. Cleaning out and making sure there are no cold joints on the OBD connector as well as the Flash Connector
2. The Openport pins are not making proper contact, I resolved this by using a cheap OBD port extender on Ebay. Cars that gave trouble to connect or maintain a stable logging connection never gave issues after doing this

 

WIll do, just to be clear the flash connector is the green wire right?

 

Cleaned the obd pins and re did the reflash connector, works like charm now! Thanks!!!

 

Anyone here have disabled the egr on airtrek? Tried to disable from ecuflash but i still get cel and p0403 code. What else do i need to change?

P.s i removed all the egr solenoids since they're dead.

 

your trek is 2002 or 2004?

 

It's an '03 so i guess it's the same as '02?

 

can you post your rom?

 

sure.

 

try this rom

 

Will do! Do i need to change anything or just flash it in?