TephraMod V7 - How to enable EGR? Factory Lean sppol setting?
TephraMod V7 - How to enable EGR? Factory Lean spool setting?
What setting do I need to change to enable EGR?
Is the lean spool supposed to be disable from factory? If not, what setting does it need to be start/stop RPM.
USDM Evo IX
Option 1 88590715 (v7)
Option 2 - Thanks to recompile 88590715 (v7 + Mods)
Is the lean spool supposed to be disable from factory? If not, what setting does it need to be start/stop RPM.
USDM Evo IX
Option 1 88590715 (v7)
Option 2 - Thanks to recompile 88590715 (v7 + Mods)
- Setup for JDM MAP and PSI based boost control (mrfred)
- WGDC Correction Interval set to 1 (Stock = 10)
- Max Total Upward WGDC Correction @ 100% TPS set to 0 (Stock = 10)
- EGR System Disabled (mrfred)
- Max Timing Retard set to -20 degrees (tephra)
- FAA bit.10 disabled ("weird unknown" timing pull at cruise)
- FAA bit.09 disabled (cat-warmup ignition retard)
- FBA bit.00 disabled (lean spool)
- FCA bit.09 disabled (EGR Test)
- OBD Inspection set to Pass all tests (acamus)
- Rear O2 Heater patch applied (mrfred)
- Fuel Cut Load Limit x2 and set to 300 (mrfred)
Last edited by Jhero23; Apr 25, 2025 at 05:55 AM.
Thread
Thread Starter
Forum
Replies
Last Post