bnice01

iTrader: (4)

Seem like I have an issue and wondering if I am overlooking something. No matter what my wgc duty is after 7600 it goes to 100%. I am within target psi until the 100% happens. The wastegate solenoid activiation rpm table deactivate on/off are both set to 9000. In the TBEC I have no upward correction. When doing a log with evoscan the wga duty cycle correction shows 0. I know if the WGSA rpm is set below your rev limit that this happens but it sets beyond reach. My rom ID is 94170015, is this a VIII thing that has no fix?

Thanks
Brandon

GST Motorsports

iTrader: (8)

Your defination is wrong for your rom. Couple others have had that problem here and that is the solution. What address are you using?

bnice01

iTrader: (4)

thank god, man I was pulling my hair out yesterday. My current address for "wastegate solenoid activation rpm" is 1668. Is it suppose to be set to 1A68, I remember seeing that some where when I was searching late last night?

thanks bryan for helping

GST Motorsports

iTrader: (8)

I don't have my laptop close currently so I'll have to check later tonight unless somebody posts it before.

bnice01

iTrader: (4)

Sweet dude

If you are ever in the panhandle, is on me

GST Motorsports

iTrader: (8)

Just checked, 1A68 is correct and what you should be using.

With 1A68 it should look like this in a stock rom:

Reactivate On 2250
Reactivate Off 2156
Deactivate On 7500
Deactivate Off 7500

To increase the RPM on which it automagically shoots to 100% WGDC just up both the Deactivate On/Off values

bnice01

iTrader: (4)

Thanks bro, you are a life saver.

GST Motorsports

iTrader: (8)

No problem. Glad I could be of help.