Running FIC 2150's
#1
Evolving Member
Thread Starter
Running FIC 2150's
How many of you guys are running them? I just threw them in an 8 along with SD and finally got them to idle around 14.7 area. I'm not sure if I overlooked something or not but at initial start up, it runs extremely lean until it hits operating temps. I'm running a 1.088 min IPW with the patch.
Basically I'm looking for people who are running these successfully and see how their turnout was.
Basically I'm looking for people who are running these successfully and see how their turnout was.
#3
Evolving Member
Thread Starter
Completely different huh? Well I read a few places that you had to run open loop at idle areas and lean it out in the fuel map just to get it to idle around stoich. On top of which, using the IPW patch.
Can I ask what you did to make them run good or hint at it? Or is it your own secret?
Can I ask what you did to make them run good or hint at it? Or is it your own secret?
#4
Evolved Member
iTrader: (30)
I run them rich is what I meant, sorry I didnt explain it well. I run them open loop with big cams on an VIII normally but they can be set up on closed loop as well if you want it a little lumpy.
The MAF Comp vs coolant table looks like this stock on right and modded on left, post primer enrich decay is below that-
Any SD car will use some variation of this to cure the cold lean issue.
The MAF Comp vs coolant table looks like this stock on right and modded on left, post primer enrich decay is below that-
Any SD car will use some variation of this to cure the cold lean issue.
Last edited by JohnBradley; May 22, 2013 at 11:58 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Konakev
09+ Ralliart Engine/Turbo/Drivetrain
2
Oct 25, 2016 02:07 PM
[FS] PTE 1000cc injectors
slammedndirty
For Sale/WTB - Engine / Drivetrain / Power
1
Nov 28, 2014 06:44 PM
c_james
Lancer Aftermarket Forced Induction Tech
14
Sep 5, 2011 10:11 PM