Daniel's 821whp SLR2.2 4G63 3794 TS
#62
Evolving Member
Glad to see this thread, because this is probably the basic engine build I would want from you guys when I eventually get down there.
That is, 4g63, 94mm crank, 153mm rods, 1400HD pistons, but I would want lower CR pistons - for 92 octane pump gas.
My engine is a 1990 6-bolt which I suppose rules out the K1 crank, but the Eagle 4340 6 bolt crank should be fine shouldn't it? Everything else in the build I would want simmered down to about the 500-550 whp level.
Hope you are still offering the $200 ride on a trailer when the time comes!
That is, 4g63, 94mm crank, 153mm rods, 1400HD pistons, but I would want lower CR pistons - for 92 octane pump gas.
My engine is a 1990 6-bolt which I suppose rules out the K1 crank, but the Eagle 4340 6 bolt crank should be fine shouldn't it? Everything else in the build I would want simmered down to about the 500-550 whp level.
Hope you are still offering the $200 ride on a trailer when the time comes!
Thread
Thread Starter
Forum
Replies
Last Post
JohnBradley
Evo Dyno Tuning / Results
137
Sep 1, 2016 03:45 PM
JohnBradley
Evo Dyno Tuning / Results
42
Jul 10, 2015 02:00 PM
GotWheelHop
Evo Dyno Tuning / Results
32
Dec 10, 2014 03:40 AM