FP ZERO 803HP/644TQ Crispeed Tuned built by AG Autosports
#18
Evolved Member
So if FP decides to cast a stock flanged Super 99 would that be considered stock also! lol
No problem.
#19
Well in the DSM world they use the stock flange turbine housing on HTA 86 turbos and it counts. I know they used to offer T67 P-trim turbos as bolt on too.
#22
Is there a build sheet for this beast!? Mainly wondering cams, intake manifold, and what's done with the head. Sick build. Looking to get into a Zero and not sure if it would be a good idea or not to ditch my S2 cams for the S3's for 750-800whp
#27
You can tell the RPMs by scaling to where HP & Tq cross which is always at 5252 rpm.
By eye, it looks to me like they cross at 58.8mph -> 89.3 rpm/mph.
So the red curves go out to 78.1mph or 6976 rpm and
the blue curve go out to 89 mph or 7949 rpm.
By eye, it looks to me like they cross at 58.8mph -> 89.3 rpm/mph.
So the red curves go out to 78.1mph or 6976 rpm and
the blue curve go out to 89 mph or 7949 rpm.
Thread
Thread Starter
Forum
Replies
Last Post