Where would be the best place to run the wire from the O2 sensor to the inside of the car. Is there a place I could run it from the bottom of the car or would I have to run it to the engine compartment through the firewall? Any help would be appreciated. Thanks in advance.

 

if you look under your car there are groments. Atleast on the pass side i plan on running mine that way the cord is plenty long enough.

 

Can you tell me exactly where they are and will I have to take out the seat or the carpet?

 

run it through the same hole the stock o2 sensor runs in.

 

Thanks for the help guys

 

I ran mine under the dash and over to the passanger side then I pulled up the carpet on the passenger side floor board and there is a rubber plug there that i pulled out and ran the wire for the sensor through. It hardly fits through the hole but it will with some work. Also you have to remove the center consol in order to lift the carpet up to do this. It is very easy though.

 

I took the passenger side seat out to have plenty of room. Just four bolts to remove and it's out.

 

Thanks alot guys I dont know what I would do without you!!!!!!! THANKS!!!!!!!!!!!!

 

I ran mine through the grommet under the drivers seat, and just zip tied it to the lines.







GL.