Hey everyone, as you can see I've been a member for a while but I rarely post because I use the search button to the full extent. I have a question though and I can't seem to find the answer.

Will the QTP downpipe with the E-cutout fit with my beatrush undertray?

QTP doesn't know and the shop that is doing the work for my Evo isn't sure either. Anyone with that setup?

If not, does the Beatrush fit most aftermarket downpipes? Im assuming yes..but id like to make sure before buy anything.

 

I am also interested in wondering if the QTP downpipe will hit the beatrush panel with the cutout. Also, is there anyone out there who might have cut their beatrush panel to fit either a IC, or similar exhaust cutout?

I am just wondering because I love the beatrush panel, and if I ever need to cut into the panel to make clearance for something, I want to see if cutting the panel causes the panel to deform slightly. Also would like to see if anyone has done any cutting of the panel with a torch, or some other welding tool. I would like to work around the panel, in other words.

 

I run the Beatrush panel with my Buschur Tubular turbo kit and open dumptube. The dumptube exits right at the passenger side air vent..just had to cut a little bit and it works like a charm now. I realize you guys are asking about the QTP cutout...I can't help you there, but I'm sure you can make it work.

 

the beatrush undertray doesn't reach much further out than the stock unit if any. The qtp works with the stock undertray and I am 99% positive it will be alright.