Tomei Arms Turbo installed!!!
HB Speed has tested 2 cars with varying mods using the ARMS turbo.
They have an interactive dyno-page now that you can check out here:
http://hbspeed.com/dyno/index.phprun...&torque=1&gb=0
Use drop down feature to find the IXs that Marco and Phillip are running. All runs were on 91 octane, they even have one with bolt on's minus cams, then after cams.
They have an interactive dyno-page now that you can check out here:
http://hbspeed.com/dyno/index.phprun...&torque=1&gb=0
Use drop down feature to find the IXs that Marco and Phillip are running. All runs were on 91 octane, they even have one with bolt on's minus cams, then after cams.
I have the Tomei turbo on my IX with all the supporting mods, cosworth m2s and made 368 whp 341 ft/lb to the wheels at about 23-24 psi on pump gas 91 oct. Now you might say the numbers are low but that's how their dyno reads.
Tomei on my IX
In comparison, the same shop on the same dyno tuned a Evo IX with a FP red with similar supporting mods, 272 cams at around the same boost 23-24 psi on pump gas 91 oct and made 391 whp and 343 ft/lb wtq.
FP Red on a different IX
Of course the FP Red is going to make more power since its a bigger turbo. So far I'm enjoying my Tomei turbo...the response is very very good for my DD IX.
Tomei on my IX
In comparison, the same shop on the same dyno tuned a Evo IX with a FP red with similar supporting mods, 272 cams at around the same boost 23-24 psi on pump gas 91 oct and made 391 whp and 343 ft/lb wtq.
FP Red on a different IX
Of course the FP Red is going to make more power since its a bigger turbo. So far I'm enjoying my Tomei turbo...the response is very very good for my DD IX.
Last edited by u189961; Oct 21, 2009 at 05:39 PM.
It seem that a lot of folks are asking for pump 93 dyno graph. Here is mine. I know I have some boost leak somewhere and my clutch started to slip so the graph might not be as accurate.
I will have Fidanza 3.2 and Comp flywheel installed next week. MAP ported my intake manifold and upgrade my clamps and stock couplers with Extreme PSI 4-ply silicone couplers. Hope that should stop the boost leak during my next dyno this March.
Enjoy
I will have Fidanza 3.2 and Comp flywheel installed next week. MAP ported my intake manifold and upgrade my clamps and stock couplers with Extreme PSI 4-ply silicone couplers. Hope that should stop the boost leak during my next dyno this March.
Enjoy
