Check engine light w/ test pipe
Just put on my Buschur 3" turbo back w/ magnaflow muffler yesterday. First off, great fit, great finish, not too quiet, not too loud, and lots of power. However, this morning I got a check engine light (CEL). I realize that this may be because the 2nd o2 sensor is not recognizing a catalytic converter, but I didn't think that people were having problems with that. Earlier in the day i was playing with my AFC and went out of range with it for a moment(which is another possible cause of the CEL), but I didn't get the CEL until about an hour later. Anybody had this problem yet? Anybody know a fix or know if its ok to run with the CEL if its because there is no cat?
THANKS!
THANKS!
Thread
Thread Starter
Forum
Replies
Last Post
nikkonikko
General Engine Management / Tuning Forum
4
Oct 23, 2011 06:24 AM
Hungbee112
Evo Engine / Turbo / Drivetrain
7
Dec 22, 2004 10:10 PM




