hey guys what do you think about adding these to the BBK turbo

http://store.forcedperformance.net/m...410117901BBK84

http://store.forcedperformance.net/m...pressor_01.jpg

 

For 75, its worth trying. I'm not sure I'd shell over $200 for it, the BBK doesn't surge.

 

it'll make it sound like a jet cruising around like the red and black.. id do it. just the sound alone is worth $100 lol.

 

not sure if it would work as I think FP ports the inside to a certain extend to fit thier wheels. just my guess!

 

site says its machined to fit.

 

The cover is setup for the BBK..

Mike

 

lol my bad fellas...didnt even know fp made covers for the bbk's and didnt check the op's link..lol
*gets a time out and goes ot the corner*..lol

 

Depending on the boost you run they do surge.. This would make for a nice upgrade for 75.00 shipped.. Id be curious to see if any power gains as well..

 

+1 for the fighter jet sound miss my black for it

 

You may be able to even order the BBk with no front cover then add the FP Cover.. Might not even cost you anything..

 

This really would be a good alternative, Mike. But, I really doubt that CBRD will ship it without the compressor housing. But, like they say....It wouldn't hurt to ask.

I asked once whether they would configure a BBK with a 9.8 turbine housing cut for the BBK exhaust wheel and Chad stated that they only configure the BBK with the 10.5 housing. I got the impression that the BBK is pretty much a take it as is turbo. It is not like: hold the mustard

 

or u could send the fp housing to chad and have him send u the turbo asembled.

 

They should make one for the new HKS turbo >:].

 

Yeah, an 84mm FP cover cut for the HKS comp wheel. Additionally,
set it up with a 4" intake pipe and SD on E-85.

 

hepl me out, is this so you can run a bigger intake?