raiceboi697

iTrader: (42)

After reading all this im just curious as to what would happen if one of the large plenum intake manifolds would be used? I would assume that the power curve would be pushed to the right and that a lot of the low end punch would be lost and it would be more suitable on a car that is more set up for drag duties. At least thats what i gather from reading this..

David Buschur

iTrader: (53)

Both intakes used have large plenums.

n2oiroc

iTrader: (33)

where does your intake come in? bigger than stock and smaller than the big plenum intakes i imagine?

David Buschur

iTrader: (53)

Yes, bigger than stock, smaller than the others and has longer runners.

n2oiroc

iTrader: (33)

hmmm. me thinks this sounds pretty good for my efr 8374 2.2L. im in the market because i just sold my large plenum di. i was afraid the plenum volume was going to be a bit much.

raiceboi697

iTrader: (42)

I know both intakes manifolds mentioned have larger then stock plenums but I was more referring to the large plenum DI intake manifold

n2oiroc

iTrader: (33)

fyi tom from di told me its 300ci (4.91L) and the small is 240ci (3.93L). i thought i read that the magnus is 5L. btw, what is your setup?

raiceboi697

iTrader: (42)

My set ups front facing 3582hta and some m2s and all the other bolt on goodies

EvoPower81

iTrader: (14)

I have a built 2.4 Pt6262 and im also looking for the best Intake manifold which gives the best hp and not sacrificing too much, if any, torque and response. Afterall its first and foremost a street car. I am leaning towards the buschur ,DI or AMS. I like the idea of buschurs with the longer runners and maybe the smallest out of the big plenums which should give me the best of both worlds

David Buschur

iTrader: (53)

When we did our intake testing/development, Tom contacted me from DI. Asked what we found, I told him about the plenum size issues. That same week he built the "small plenum" DI intake manifold to the plenum specs we discussed and found to work and shipped us one for testing.................thank you.

LGshow19

iTrader: (51)

So is there any similarities between the DI manifold and BR manifold?

David Buschur

iTrader: (53)

There are pictures of both on our site. This thread is about Magnus and AMS, I don't want to take it off topic. Start a new thread, send me a link or whatever, please.

LGshow19

iTrader: (51)

My bad, i apologize. Ill go head and start a thread about the BR Intake mani vs DI intake mani.

lillev23

iTrader: (34)

So if the smaller plenum is better for smaller displacement engines, is it safe to say that a the displacement increases so should the plenum?

lillev23

iTrader: (34)

I think we need a intake manifold test 2.0. There have been so many revisions to all the intakes, so I think we she where they all stand.