Fitting bigger turbo then driving before being mapped
Fitting bigger turbo then driving before being mapped
Evening all near enough got all the bits now so I can fit my gt30 setup, will I be ok to fit it then drive carefully off boost until I get the car mapped?
Engine is a 2.4 currently setup to run actuator pressure 0.7 bar from when I ran the engine in.
Craig
Engine is a 2.4 currently setup to run actuator pressure 0.7 bar from when I ran the engine in.
Craig
Evolved Member
iTrader: (11)
Joined: Oct 2007
Posts: 1,430
Likes: 1
From: Connecticut / Massachusetts U.S.A
You can safely drive to your tune as long as you never enter boost. Also, make sure your boost controller is turned all the way down (just as another precaution).
Do you have bigger injectors installed? If so, make sure they are scaled correctly before you drive. Ideally, you would want to leave the stock injectors in and when you get to the shop, install the injectors in the parking lot, they are easy enough to do.
-Bink
Do you have bigger injectors installed? If so, make sure they are scaled correctly before you drive. Ideally, you would want to leave the stock injectors in and when you get to the shop, install the injectors in the parking lot, they are easy enough to do.
-Bink
Thread
Thread Starter
Forum
Replies
Last Post
craig05evo
For Sale/WTB - Engine / Drivetrain / Power
16
Aug 23, 2013 09:03 AM
06MREvo
Vendor Service / Parts / Tuning Review
36
Oct 17, 2009 08:51 AM





